![]() ![]() ![]() Set *FFFFFFFE local-address=192.168.89.1 remote-address=vpnĪdd bridge=bridge1 interface=ether2-masterĪdd address=192.168.0.9/24 comment=defconf interface=ether3 network=\Īdd comment=defconf dhcp-options=hostname,clientid disabled=no interface=\Īdd address=192.168.0.0/24 comment=defconf gateway=192.168.0.9 netmask=24 Set supplicant-identity=MikroTikĪdd comment="Block Torrents" name=block-torrents regexp="^(\\x13bittorrent pro\ "created from master port" name=bridge1 protocol-mode=none You want you Mikrotik to act as a router and AP, or only as AP? If you want to have the same subnet on fiber modem LAN interface and on the Mikrotik LAN interface, you should connect the fibre modem to the Mikrotiks LAN, not WAN interface (and disable DHCP server on Mikrotik to make sure Mikrotik will act as sole AP). You should also set correct default gateway, correct interface in scrnat NAT chain (ether1 instead of PPPoE) and change the input firewall rules to block unwanted traffic on your ether1 port.Īlso, when "192.168.0.9 and 192.168.0.2" are on the same subnet (I assume /24 mask), the same subnet cannot be on WAN and LAN simutanelously. When change to fiber modem, you should set correct addresses (or DHCP clients (by "/ip dhcp-client add interface=ether1 disabled=no default-route-distance=1" command )) on your ether1 interface directly. Generally, bridge/PPPoE interface is a virtual interface upon physical ether1 port of your Mikrotik. Could you please export and post here the whole configuration ? (by "/export hide-sensitive file=config" command) ? ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |